Camsensor Wood Vision has worked in a number of areas in the finger joint manufacturing process. Two key solutions are to do with scanning prior to the fingerjoint process and are outlined below. In addition development work extends to quality control of the finger joint itself, including glue application and pin hole detection.

---

Crosscut Saw Scanner

Camsensor Wood Vision Crosscut Saw Scanner is designed to be easily installed prior to a crosscut saw, either replacing a current manual mark detection system, or as a full grading and optimising system controlling the saws directly.

Find out more >

---

Lumber Trim Scanner

Camsensor Wood Vision Lumber Trim Scanner, scans both ends of a board travelling transversely, and controlling end trim saws to remove defects that would compromise the finger join, at the same time minimising waste cutting as close to the inside of the defect as possible.

Find out more >

---